| KNX-Lunos-Control4-IW | |
|---|
| Operating voltage | KNX Busvoltage 21 .. 32VDC |
| Power consumption (KNX) | ca. 120mW ( @ 24VDC ) |
| Bus voltage connection | KNX-2-pol Clamp ( red / black ) |
| Auxiliary voltage | 24V .. 32VDC 20W max.
( 5W / 10W / 15W / 20W @ 1..4 fans ) |
| Connection AUX-voltage | WAGO-Clamping block ( yellow / white ) |
| Electrical efficiency of module | 92% ( With maximum power ) |
| Button / switch input | 3mA Potential -free / debounced |
| Busoppler | integrated |
| Ambient temperature | storage -20 .. +85°C
operation -5 .. +45°C |
| Humidity | up to 90% not condensing |
| Power reduction | Automatically from 75 ° C modul temperature |
| Commissioning with | ETS Arcus_Lunos_Ex_v5.knxprod |
| Protection class | IP20 |
| Installation of KNX module | Standard Inwall ( 60/68 ) mm |
| Housing of KNX module | Plastic black |
| Dimensions of KNX module | ( 50 x 50 x 20 ) mm ( B x H x T )
58mm Diagonal |
| Article number | 65001002 |
For suitable ventilation devices with heat recovery as well as pure exhaust air devices, see Lunos Homepage (www.lunos.de).
## Commissioning
The KNX clamp is connected to the KNX bus via the supplied terminal block (red (+) / black (GND)).
The auxiliary voltage is connected via the supplied terminal block (yellow (+) / white (GND)). The fans are mounted according to the lunos specification and connected via the supplied preceded connector. Optionally, potential-free button / switch can be connected via the supplied connector.
Under no circumstances may the module be connected to mains voltage potential.The installation may only be carried out by a specialist.
 | Lüfteranschluß | ACM-Modul Anschluß |
|---|
| violet | violet | 0-10V |
| red | red | +12V |
| blue | blue | GND |
Connection options for different lunos fan types
| Fan-type | L1.A | L1.B | L2.A | L2.B | |
|---|
| Nexxt / LUNOMAT | | X | | X | |
| e² of any type | X | X | X | X | pairwise* |
| e²60 | X | X | | X | unpaired* |
| ego S1[R] | X | | X | | |
| ego S2[L] | | X | | X | |
| Silvento (FK, EC, 30/60/100) | | | X | X | |
| RA 15-60 | | | X | X | |
| ACM-Modul or 0..12V | | | X | X | |
*It is important to ensure that with any type of e² the same number of exhaust-(A) and supply air fans (B) are always connected across the installation.
The only exception applies to an unpaired operation of 3 e²60 fans. To work in unpaired mode, the fan type e²60 must be selected on the main configuration page and the fan speed must be adjusted under System / Flow Rate.
